What is Hilti's recommended proof load for pull out testing an M16 HAS-U GR8.8 @ 200mm embedment with HIT HY-200R V3 Adhesive?
Hi db915,
Thanks for reaching out to Hilti.
The testing load for anchor onsite testing will depend on many factors, such as the purpose of the test and geometry of the anchor group.
In Australia, we recommend following the guidelines from AEFAC, the Australian Engineered Fasteners and Anchors Council. Their TN 05, volume 2 (Microsoft Word - Site testing - Vol2 - Revised.docx). The document provides guidance on how to define the testing load on section 4 (in case you're looking for proof tests to check installation quality).
I would suggest you read this previously answered question for more information about anchor site testing guidelines: Pull Testing Chemical Anchors - Pull testing, drill and epoxy ...
We have also published an article about anchor testing: Final step to gaining confidence in installation quality of po...
I hope the above is helpful, but please reach out if you have further questions.
Kind regards,
Ask Hilti team