Engineering Center

Hi We have an existing antenna pole base that is installed on a concrete slab using chem anchors. However, the build team did not use grouting and have left an excessive gap between the base plate and concrete slab. Due to space restrictions, we are trying to remove the steelwork and base plate and reinstall at the same locat...

Can post-installed cogged bars be tested?

Hi, I run the profis however it wont calculate the design and keep loading. Please advise

i need a solution for local brick failure mode, knowing that using brick of higher strength will enhance but not that much that the connection still unsafe

We have a project where a sub-contractor has incorrectly located and installed the chemical anchors for a baseplate and had to force them approximately 15mm into position to fit the steel baseplate over. Will the anchor capacity be affected by this? I believe they may have forced them with a hammer. We are using RE-500 chemica...

Hello, i need to anchor M20 threaded rod chemically into rock i have checked the embedment length into rock, i need to check the eyebolt(ring it self) as shown in attached photo ,can you please provide the M20 eyebolt capacity table?

In recent designs, enabling the filling of the annular gap has not increased the shear resistance of the anchors but rather has decreased them. What is the philosophy behind this?

Hilti Profis seems to be updated with lots of features I don't need, and yet I'm unable to check the capacity of a single anchor. I just need to check simple anchors connected to a baseplates. No advanced baseplate analysis, no profile. Just a simple check. If there a way to do this with the new software? Or am I able to use t...

I have purchased the software please advise how I log into the web site to use the software

Our pump supplier has recommended 6 x M36 anchor bolts to be installed into the 32 MPa reinforced concrete plinth. Please recommend a suitable anchor bolt system to specify. I was looking at Hilti HIT-RE 500 with HIT-V / HAS-E, M36x330, but I am unsure if I have these codes correct. Application is outdoors, exposed to weather.