Engineering Center

I have registered for the Concrete-to-Concrete Connections live event but do not think I will be able to attend. Will it be recorded and be able to be viewed at a later time?

Hi Guys, Appreciate your assistance we have supply US Navy with solar street light poles on GUAM We are supplying 6x Aeromax solar lights on 5.5M poles with 4x M30 bolt patten / typically uses we have available M30 HDG 800 x 30mm J-Bolts . Installer wants to use Chemset Anchors here. They have requested we use SS316 anchor...

Hi, I've been trying to get a fixing to hollow brickwork to work for only 5kN shear force. It's for a mullion connecting to 140thk hollow concrete brickwork to prevent some lateral movement. I used HY270 chemanchor with sieve sleeve with 85mm length insert; setup with hollow normal weight concrete brick (200 x 200 x 500 as ...

Pls advise the best way to fit 980 x 100mm M10 threaded rods to a flat roof to be used to hold bracketing for solar panel installation. The flat roof (26 floor 5 star hotel) has not yet been poured and I wanted to know if best to fit the bolts pre-pour or to post fit the bolts. There is a lot of concern over the waterproofing ...

Does this program account for the concrete that the anchors are going into if its reinforced as I know there is a reinforcement tab under base material but when changing those inputs it does nothing to the results. Is there a way to untick a box to ignore cone pullout?

We are trying to find the required embedment of anchors in rock. The rocks are typically sandstone, shale/siltstone, and dyke rock in Australia. We cannot find any information about the ultimate bond strength of Hit RE500 V4 to these types of rock. Do you have any new data we can use in our calculations? Or do you have recomme...

Are there any anchors which can be specified into 50mm thick concrete stair treads

Hi, we are constructing a 7 level apartment building in Brisbane ( Type 2 construction, Earthquake design category 2 ). Can you please advise if your Hilti HUS 3 A and HUS 3 I fixings comply with AS 1170.4 when used for hanging plumbing drainage pipes from a concrete slab above. A repose at your earliest possible convenience w...

We need fixtures tested on an existing facade, good access Fixtures are to underside of soffit

Hi, we need to get a countersunk anchor to work under a moment of 7.23kNm and couldn't find a solution. I tried to increase the plate thickness for more strength but Hilti isn't letting me do that. Could you have a look and see if there's a good solution to it? Thank you!