Engineering Center

Can I use expanding foam to fill the void at the bottom of a hole in the slab to prevent the chemical mix from falling though...the slab is only 100mm thick and I need to install 80mm anchors.

Hello, I am trying to verify a design of post installed anchors to concrete which will be subject to fatigue load cycles. However, I can not see how this is undertaken within Hilti PROFIS. Please can you advise whether PROFIS can be used for fatigue design verification? Thank you

Hi, I recently attended in the Project Application Series - Part 2: Facade applications session. I would like to ask if you will, or you can issue a certificate of participation for this webinar. Thank you. I will attach a photo of proof that I attended the session.

Do Hilti's specifications require a minimum spacing between existing anchors and new anchors when installing new Hilti anchors with HY-200 next to the existing ones?

I am trying to source a suitable firestop product to fill a gap around a 100 diam conduit through a floor penetration (which has an irregular shape. It must satisfy a FRL or 240/240/240. Do you have anything to satisfy this need?

I have been using the free standard license of PROFIS engineering software for some time, but would like to trial the premium features, specifically to test a baseplate with stiffeners. Every time I click 'upgrade to premium' at the top of the software, it takes me to a page to choose the level I wish to subscribe to, I then c...

We have been using the Hilti Profis software for selecting anchors for our columns and we are currently working on a project where the site slab is built using Steel fibre reinforced concrete and no mention of rebar use in the slab specification, does it effect the capacity of the concrete.

Dear Hilti Support, Have the Hus4 6 anchors got ETA C1 or C2

Just wondering what does the AM standard for and what are the difference of an AM threaded rod to HAS rods?

I changed the standard from the Australian Standard to European code, but now it doesn't give me the option to revert it back to Australian standard. How can I do it?