Engineering Center

Hi, I am looking at a possibility of using Hilti HIT-RE 200/500 to install an anchor with a bend into concrete for a post moment connection. Does Hilti have any experience or research to show that a bent anchor in tension works well in practice or is this not a recommended solution? How close does the capacity of a bent bar co...

We are looking at seismic design for commercial construction on wall system attachments

I am proposing to support a bulkhead from the slab above so I need a drop anchor that is earthquake resistant. It would appear that Hilti HSC undercut anchors would suit but I want to make sure that they are available and also want to know if there are any other options available to me.

I just wanted to confirm the maximum plate fixing for a HMU PF 80/20, I’m 99% sure that I once the HMU is set using the stop drill bit and the setting tool, that you are left with 35mm of exposed thread/shank and that you can fix a 20mm thick plate.

If the cavity is less than 100mm, can we trim down the barrier to fit the cavity?

1 x Hilti X-CC DKH ceiling clip will hold 86kg acording to your data sheet. What factor of safety has been included in this figure

I have an application where I want to secure vibrating equipment and I want to use a product which is resistant to fatigue. I am considering HIT-RE 500 V4. A limitation is that the bolt holes provided on the equipment are 20mm diameter, and I want no more that 2mm oversize of the holes, requiring an 18mm anchor. The HAS anchor...

Hello! I would like to know how your (Anchoring to Concrete) program calculates baseplate thickness.

Hi I want to design cast in anchors

What is the maximum embedment length can be achieved with the following bolts: M27 8.8 M20 8.8