Engineering Center

Hi How much uplift load capacity can I get from using the chemical anchors for fixing to granite? Can I consider it like regular concrete (base material) when I check the capacity on Profis Engineering?  Additionally, what is the M16 chem anchor's clearance hole required for granite?  Thanks a lot,

Can we use the Hilti firestop sealant for sprinkler pipe (50mm) penetrating through masonry wall. If so installation method and test report.

Hi, Could you please explain why a 79mm embedment depth has lower utilization than a 110mm embedment depth? All design parameters are the same, only the embedment depths are different. I merged two design outputs with different embedment depths into one PDF. Could you please review the attachment? Regards, Steven

Not able to solve when i am using supplementary reinforcement switching to SOFA.

Do you know if there is any requirement under Australian Standard to provide pull testing of installed chemical anchors?

In relation to the use of Profis software

Dose the new x pin fit in a dx5

Good Morning, What is the maximum length available for M12, M16 and M20 HIT-HY 200-R V3 + HAS 5.8 anchors? Also, are you able to provide 150mm embedment length for M12 anchors?

Is there a design program for Cast In Channels?

There is an internal brick wall perpendicular to a brick party wall. If the structure is deemed adequate, in Asutralia, can a steel beam be supported by the party wall when the internal wall is going to be removed?