Engineering Center

Hi Hilti team, We are planning to use Hilti material. Our case is that of concrete base slab attached to concrete vertical retention system (PROFIS Engineering) The construction site is in Australia. There is no concrete-to-concrete module tailored to Australian Standards, but I am using the one from the closest country, Ne...

Does Hilti have options for large anchors over 40Dia? We're looking to us 48 dia anchors (M48 G8.8 threaded rods) for large vessels/equipment in mining application. Any advice would be greatly appreciated.

Hi, Wonder if I can get the info on suitable bonding materials for anchor plates with thickness 4mm in relation to strengthening a bridge girder

Since around April / May, I have been trying to upgrade my subscription for a paid version. Online support wasn’t able to help me. Furthermore, when I tried to email auteam.askhilti@hilti.com, it asked me to post the question here. Could you please get back to me regarding the above so I can start using the paid service. Kin...

Hi, Does concrete edge failure to be checked separately while using Hilti chemical anchors or providing minimum edge distance is sufficient?

Hi there, Can we install a chem-set once the 50MPA concrete reaches a strength of 35MPA. Is that possible?

We need to anchor some tunnel forms into rock behind to resist concrete lateral pressure during concreting. The anchor loads very from 100 to 140 kN (working loads). We are thinking to use Z bars with Hilti HIT-RE 500V3 epoxy. The rock is classified mostly sandstone types 2 and 3. Can you please advise whether it is a right pr...

I would like to use Hilti HUS4 M16 screw-in anchors for fixing to rock, due to simplicity of installation in a tunnel. The rock is extremely hard 100MPa Will Hilti screw-in anchors work as intended when installed into such hard rock? Chemical anchoring is not an option for this project.

Hi Hilti, Are you able to provide the historical design installation and capacity details for HY150 circa 1989 please. Is there a design life for the installation under cycle loading?

Wondering what base material bricks to use when modelling extruded brick connection in Profis to meet Australian Standards, I don't see any options that are close to the Australian common bricks.